Just waiting on some measurements before I sew up the rest of the suit :3 should have new epoxy in tomorrow, discovered my last box of miliput decided to go too hard for my hands to work :/
Gots some clay delivered today so I'll be gumming the teeth and then popping em in :3

Just realized I stuck the red eyes instead of the green eyes in the photo! (they were next to each other lol meanie eyes!!).

Silicone for paw pads arrived yesterday so I am in the process of sculpting the paw pads. I have stuff that's shoreA70 (PT Flex 70 Hard PU Rubber) for the feet (can get shoreA85 too but I figured I would try it a little lighter) and I have Dragon Skin 20 for the hand paws.
I have found that for noses Dragon Skin 20 is not swishy enough for me so I'll be moving over to 10 for that :3

Depending on how the PolyCraft works out I could see a shift in materials or at least a partial shift.

Keep in mind if you are taking notes from me that Dragon Skin is a Platinum Cure Silicone Rubber, whereas PT Flex 70 is a Poly Urethane Rubber. These materials will not work properly if you use the same molds. You will get cure inhibition and a large gooey mess, probably destroying your molds. A mold built to use Dragon Skin can NOT be used for PT Flex PU rubber.
So don't say I didn't warn you!!

OH! got wolf claws coming too so I can make claw molds, Vyper's a fierce pup!

For now... Halloween preparations begin! (that and saving my bed from the cat) I have an alter to construct and scones to bake!