Here is an update on the project I had previously submitted here https://www.furaffinity.net/view/62951323/

It's still a work in progress, but I wanted to show off what I have gotten done so far on the rear portion of the portable forge I have been making.

Here the viewer can see the guide blocks I made to hold the sliding bolt for the door that is part of the tinner's stove portion of the forge.

It took over 12 hours of sawing and filing to make these 3 little components and I am absolutely bewildered by how long it took. I'll probably figure out a quicker way next time, but for now I can show off how nice the flush rivets are.

I'm close to finishing this entire forge, but this door here was probably the most complicated part of the whole unit.