FA+
Shop
251
Views
Views
3
Favorites
Favorites
Category
Crafting / Miscellaneous
Species Unspecified / Any
Size 2283 x 1614
File Size 573.1 kB
Report this content
More from MinusK
Listed in Folders
I modeled, printed, and circuited this Jack-O'-Lantern with a cat face.
I used bi-colored gray/orange Matte PLA for the base, and green PLA for the stem.
I used these electronic components: SS12F44-G5 switch, HiLetgo CR2032 Battery Holder, 3V CR2032 battery, some wires, a 68-ohm resistor, and a DiCUNO yellow LED.
Here's a link to the STLs if anyone wants it: https://mega.nz/folder/g2RBCSBA#hNk.....9JALQrebPNqueA
I used bi-colored gray/orange Matte PLA for the base, and green PLA for the stem.
I used these electronic components: SS12F44-G5 switch, HiLetgo CR2032 Battery Holder, 3V CR2032 battery, some wires, a 68-ohm resistor, and a DiCUNO yellow LED.
Here's a link to the STLs if anyone wants it: https://mega.nz/folder/g2RBCSBA#hNk.....9JALQrebPNqueA
Category Crafting / Miscellaneous
Species Unspecified / Any
Size 2283 x 1614px
File Size 573.1 kB
Comments