FA+
Shop
315
Views
Views
1
Favorites
Favorites
Category
Other / Tutorials
Species Avian (Other)
Size 1280 x 959
File Size 156.4 kB
Report this content
More from Gilrandree
This is the pulled cast from the kenku mold. You can see the damage in the casting on the beak, where too much epoxy pooled in one place. I may make another casting from the mold (which is entirely intact), or just clean this one up.
Category Other / Tutorials
Species Avian (Other)
Size 1280 x 959px
File Size 156.4 kB
Thanks... I'm a bit disappointed in the pool of epoxy which sits at the end of the beak, both in terms of the burning visible in the epoxy and the excess weight it imparts. Since i took that, I sanded it a bit, and think I can clean up the surface, and probably can dremel out some of the excess weight.
Hopefully. Wouldn't be too hard to do another cast, if I had to, anyway.
Hopefully. Wouldn't be too hard to do another cast, if I had to, anyway.
Comments