FA+
Shop
922
Views
Views
27
Favorites
Favorites
Category
Artwork (Digital) / Miscellaneous
Species Husky
Size 1280 x 800
File Size 250.1 kB
Report this content
★
More from Kasey_The_Husky
Engine Install Take One
This absolutely stunning piece was done by my good friend 
to celebrate my car being completed after almost two years. There's still a couple small kinks to work out, but it's progressing nicely.
I would like to thank RJ for being such an awesome friend and tailoring this picture to pretty much my exact requests. I can't even begin to convey my satisfaction with this. Those of you who know these cars will recognize every part pretty much instantly. Even down to the lost 10mm wrench.
to celebrate my car being completed after almost two years. There's still a couple small kinks to work out, but it's progressing nicely. I would like to thank RJ for being such an awesome friend and tailoring this picture to pretty much my exact requests. I can't even begin to convey my satisfaction with this. Those of you who know these cars will recognize every part pretty much instantly. Even down to the lost 10mm wrench.
Category Artwork (Digital) / Miscellaneous
Species Husky
Size 1280 x 800px
File Size 250.1 kB
owo not bad! When I was debating on which car I should get, it was between a 2001 Nissan Maxima and a 2008 Subaru Forester.. I chose the Maxima for more power over AWD, but even so, it would have been an awesome car to have <3
Also note, it looks like the cam cover looks more wide like a DOHC setup when the front timing belt cover shows an SOHC setup x3 But art is art! owo
Also note, it looks like the cam cover looks more wide like a DOHC setup when the front timing belt cover shows an SOHC setup x3 But art is art! owo
Nope. The picture is correct. The phase 1 engines have smaller valve covers. The heads were redesigned for these phase 2 engines.
Here is a photo of the engine coming out before the valve covers were painted. They are quite large.
http://www.furaffinity.net/view/15239063/
Here's a picture of a dual cam cover for reference. Note the location of the spark plug holes.
http://imp-co.com/pictures/Build/16.jpg
Also, sorry for the late reply.
Here is a photo of the engine coming out before the valve covers were painted. They are quite large.
http://www.furaffinity.net/view/15239063/
Here's a picture of a dual cam cover for reference. Note the location of the spark plug holes.
http://imp-co.com/pictures/Build/16.jpg
Also, sorry for the late reply.
Comments